برامج التعامل مع الدرايف

Download - DriveMonitor Version V5.1SP3 for SIMOVERT MASTERDRIVES, MICROMASTER and SIMOREG


DESCRIPTION:

The updated version V5.1SP3 of the Start-up Tool DriveMonitor for the SIMOVERT MASTERDRIVES, MICROMASTER 3, MICROMASTER 4 and SIMOREG drive families is provided here.

Release V5.1SP3 ( V5.1.3.2 , R_051306) replaces all of the previous releases - 5.1 and V5.1SP2 and can be installed, both as stand-alone as well as an update to Drive ES Basic, from V5.1 SP2.

The download is approx. 200 Mbyte.

DriveMonitor V5.1 SP3 supports the following drives and actual firmware versions:

MASTERDRIVES VC to V3.3
MASTERDRIVES VC Compact Plus to V3.3
MASTERDRIVES MC to V1.6
MASTERDRIVES MC Compact Plus to V1.6
MASTERDRIVES AFE to V2.1
MASTERDRIVES RRU to V4.5
MASTERDRIVES CU1( V1.3 ), CU2 ( V1.4 ), CU3 ( V1.1 )

MICROMASTER 410 to V1.0 ( only in DriveMonitor stand-alone installation)
MICROMASTER 411 to V1.2 ( only in DriveMonitor stand-alone installation)
MICROMASTER 420 to V1.1 ( only in DriveMonitor stand-alone installation)
MICROMASTER 430 to V2.0 ( only in DriveMonitor stand-alone installation)
MICROMASTER 440 to V2.0 ( only in DriveMonitor stand-alone installation)

MICROMASTER to V3.09
MICROMASTER Vector to V2.0
MICROMASTER Eco to V1.09
MIDIMASTER Vector to V2.0
MIDIMASTER Eco to V1.09
COMBIMASTER to V3.0

SIMOVERT MV to V20.4

SIMOVERT PM to V5.1

SIMADYN D CBP2 as USS-Slave
SIMADYN D SRT400 CBP2 as USS-Slave

SIMOREG K 6RA24 to V2.4
SIMOREG DC MASTER to V2.0
SIMOTRAS 6SG70 to V2.0

Using this PC Tool, all of the specified drive units can be parameterized with the USS protocol via a point-to-point coupling (RS232) or as bus with up to 31 nodes ( RS485 ).

Download the appropriate ZIP file, unzip and then start the SETUP.EXE program.

The download contains all of the drive unit set-up files required for the drive families, which are supported.

This means that this download can also be used as update for new FW versions of existing drives in Drive ES Basic from version V5.1 SP1. If you use this set-up as update to Drive ES Basic, then you should install this version over your existing Drive ES Basic component and only response to all prompts during set-up with OK or CONTINUE. In these cases, NEVER change any of the default entries. The Set-up program automatically controls these.