Stroboscope uses white LEDs

تفضلوا إخواني الأعزاء هذا المشروع لدائرة كشاف ستروبوسكوب (( إضاءة متقطعة ))

This stroboscope circuit uses 16 high-brightness white LEDs in a torch housing and it provides a signal output to a frequency counter to provide a rev counter display.

IC1 is 555 astable multivibrator and it provides a signal to IC2, a 4046 phase lock loop. IC2 and the two 4017 Johnson decade counters, IC3 & IC4, make up a frequency multiplier with a factor of 60 (IC3 divides by 10 while IC4 divides by six). The multiplied frequency is taken from the VCO (voltage controlled oscillator) output of IC2 at pin 4 and this becomes the signal to drive the frequency counter. Its output reading is the speed of the shaft being measured in RPM.

A narrow positive-going pulse train to turn on Q1 and the LEDs is obtained from pin 3 of IC4. This has the advantage of giving a much sharper marker line (on the shaft) illumination.

The unit can be powered from a 12V 500mA plugpack or a suitable battery.

(Editorial note: at switching frequencies above 100Hz (6000 RPM) the persistence of the phosphor of the white LEDs will make the circuit ineffective. To run the circuit at much higher frequencies, substitute LEDs without phosphors; eg, red, green or yellow or a mixture of these)

Stroboscope uses white LEDs 10121510

لتحميل ملف المشروع ومعه مجموعة أخرى من الدوائر اضغط هنا

_________________
Stroboscope uses white LEDs 61862110

أبـوروان

جزاك الله كل خير

رائــــــــــــــــــــــــع

سيد الأستغفار
الـلـهـــم أنـت ربــــي لا إلــــه إلا أنـت خــلــقــتـــنـــي
وأنـا عـبدك وأنا عـلى عـهـدك ووعـدك ما اسـتـطـعـت
أعـــــوذ بـــــــك مـــــن شــــــــر مـــا صـنـــعـــت
أبــــــــــــوء لـــــــــك بـنــعــمــتـــك عـــــلـي
وأبـــــــــوء بــذنــبــي فــاغـــفـــر لـــــي

» white papers
» Great.White.Shark - القرش الابيض العظيم