Update of the Global Drive Control software from V4.x to V4.11

Description:
The parameter software Global Drive Control (GDC) is the efficient project environment for all Global Drive controllers.
Beyond GDC V4.10 the update enables installation of following software products:
• Global Drive Oscilloscope V1.3
• Drive Server V1.2.6.0 protected Mode (only by installation from GDO)
• Global Drive Documentation

Following Software-Products and device description and communications drivers will be automaticly installed:
• OPC-Tunnel V1.0.0.69 (Lenze IPC)
• Communication software CAN V2.1.6.0

System requirements
• Microsoft Windows 2000 (SP2) or Windows XP
• IBM-compatible PC (as of Pentium 333 MHz )
• 128 MB RAM
• at least 250 MB free harddisk capacity
• VGA graphics card
• Pointer (mouse, trackball etc.)
• Free seriel interface for the communication with the Lenze drive controllers.
• Installation of a GDC 4.x full version

Software installation
Please proceed as follows to install the update of GDC from V4.x to V4.11:

1. Unpack the ZIP-file GDC_V411_Update.zip in any directory of your PC.
2. If any GDC version is started, please close it.
3. Start the unpacked setup.exe file and follow the installation instructions.